LR-JC-01 45°Textile Fabric Combustion Flammability Testing Equipment
Uses
Touch screen control textile 45 ° burning tester is based on the specifications stipulated in the national standard 14645-2014 and developed, applicable to conform to the standard of all kinds of textiles under controlled laboratory conditions, with 45 ° inclined placed sample surface under the action of the flame combustion performance test and evaluation.
LR-JC-01 45°Textile Fabric Combustion Flammability Testing Equipment
Technical parameters
- Ambient temperature: 10 ℃ ~ 30 ℃
- Relative humidity: 15%-85%
- Power supply voltage and power: 220V + / – 10%, 100W
- Gas source: liquefied petroleum gas, in the case of third-party test results and arbitration test, propane or butane gas for industrial use as required by standards must be used.
- External dimension of the instrument: controller: 420mm*350mm290mm* combustion chamber 353mm*260mm*970mm.
- The combustion chamber is made of heat-resistant and smog-resistant stainless steel, and the front of the box is equipped with an observation door made of heat-resistant transparent material.
- Touch screen parameters:
- Size: 7 “effective display size 15.5cm long and 8.6cm wide;
- Resolution: 800*480
- Communication interface RS232, 3.3v CMOS or TTL, serial port mode
- Storage capacity :1G
- Pure hardware FPGA drive display, “zero” startup time, power can run
- M3+FPGA architecture is adopted. M3 is responsible for instruction analysis, and FPGA focuses on TFT display
- The main controller adopts a low-energy processor and automatically enters the energy-saving mode
- The burner applied 30s of flame to the pattern:
- The style to 45 ° inclined + 3 °.
- Pattern holder (sample holder) size: 490mm long and 320mm wide
- Sample size: 330*230mm
LR-JC-01 45°Textile Fabric Combustion Flammability Testing Equipment
Design standards: GB 14645-2014 textile combustion performance of 45 ° direction damaged area and the determination of the number of flame
所有評論僅代表網友意見，與本站立場無關。