預制公路路邊水泥防撞墻模具 宏旭模具 路邊水泥防撞墻模板
預制公路路邊水泥防撞墻模具當預埋件與護欄鋼筋出現沖突時，適當移動鋼筋位置，保證預埋件位置準確，清掃預制構件表面，并用水沖洗干凈，預制公路路邊水泥防撞墻模具鑿毛上根據測量確定的防護欄邊線，采用人工對護欄邊線范圍內的箱梁表面進行鑿毛處理，鑿除混凝土表面的水泥砂漿和松弱層，并用水沖洗干凈，預制公路路邊水泥防撞墻模具鋼筋的加工及安裝主線邊防撞護和匝道防撞護欄順橋向每2m設置一道假縫，嚴格按照設計圖紙對上述預埋件進行埋設，預埋件安裝要做到不遺漏，定位準確。設計伸縮縫處鋼筋要斷開，斷面要整齊。清掃預制構件表面，并用水沖洗干凈。模具生產過程中的細節會影響模具的使用和性能，對模具使用后保養方式要注重，保證模具的使用次數。When there is conflict between the embedded parts and the guardrail reinforcement, the position of the reinforcement shall be moved properly to ensure the position of the embedded parts is accurate. The surface of the prefabricated parts shall be cleaned and washed with water. The edge line of the guardrail determined according to the measurement shall be roughened on the mould of the prefabricated roadside cement anti-collision wall, and the surface of the box girder within the side line of the guardrail shall be roughened manually Chisel out the cement mortar and loose layer on the concrete surface, wash them with water, process and install the mould reinforcement of the cement anti-collision wall on the road side of the prefabricated Road, set a dummy joint every 2m along the bridge direction for the main line side anti-collision protection and ramp anti-collision guardrail, bury the above embedded parts strictly according to the design drawings, and the installation of the embedded parts shall be complete without omission and accurate positioning. The reinforcement at the designed expansion joint shall be disconnected and the section shall be neat. Clean the surface of prefabricated components and wash them with water. The details in the mold production process will affect the use and performance of the mold. Pay attention to the maintenance mode after the use of the mold to ensure the use times of the mold
所有評論僅代表網友意見，與本站立場無關。